| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| The ITE IT8xxx2 SHI host-command backend in subsys/mgmt/ec_host_cmd/backends/ec_host_cmd_backend_shi_ite.c arms the SPI peripheral before its receive context exists. shi_ite_init_registers() sets the state machine to SHI_STATE_READY_TO_RECV and calls irq_enable() while the device initializes at POST_KERNEL priority CONFIG_KERNEL_INIT_PRIORITY_DEFAULT (40), but data->rx_ctx and data->tx are only assigned later by shi_ite_backend_init(), which ec_host_cmd_init() invokes at CONFIG_EC_HOST_CMD_INIT_PRIORITY (default 80).
If the attached host processor starts a SPI transaction inside that window, the Rx-valid-length interrupt fires, shi_ite_int_handler() passes its state check and calls shi_ite_parse_header(), which stores the host-derived request length through the still-NULL data->rx_ctx. On the IT8xxx2 low addresses are not backed by RAM, and with CONFIG_NULL_POINTER_EXCEPTION_DETECTION_PMP the first bytes of the address space are explicitly made inaccessible, so the store raises a fatal access fault in interrupt context. The window widens further when CONFIG_EC_HOST_CMD_INITIALIZE_AT_BOOT is disabled and the application calls ec_host_cmd_init() itself.
The result is a kernel panic on the embedded controller: with Zephyr's default fatal handler the CPU halts, so the controller stops servicing host commands until a hardware reset. Because the trigger is traffic from the attached host processor -- an untrusted peer from the controller firmware's point of view -- software on that host can provoke the fault by forcing a controller reset and issuing transactions during the reboot, turning a recoverable reset into a persistent outage. Impact is limited to availability: the faulting address is fixed and not attacker-chosen, so no memory-corruption primitive follows.
The fix leaves the interface at SHI_STATE_DISABLED with the interrupt masked during device init, moves irq_enable() into shi_ite_backend_init() after the buffers are published, and makes shi_ite_int_handler() reject a NULL data->rx_ctx while write-clearing IT83XX_SPI_ISR and IT83XX_SPI_RX_VLISR so that an unexpected early interrupt cannot storm. |
| The Bluetooth Classic SDP server in subsys/bluetooth/host/classic/sdp.c allocated every response PDU through bt_sdp_create_pdu(), which expands to bt_l2cap_create_pdu() and therefore uses a K_FOREVER timeout. The allocation is made from sdp_pool, a fixed pool holding only CONFIG_BT_MAX_CONN buffers (one in the default configuration) that is shared with the SDP client role. When the pool is empty the call blocks without a bound.
The allocation is reached from bt_sdp_recv() on the Bluetooth host's RX context: the bt_workq "BT RX WQ" workqueue in the default configuration since v3.1.0, and the dedicated "BT RX" thread before that. This context processes all normal-priority HCI events and all received ACL data. The SDP L2CAP server is registered on PSM 0x0001 with no security requirement (BT_SECURITY_L0), so an unpaired, unauthenticated BR/EDR peer within radio range of a connectable device can drive it. Every malformed or unrecognised SDP PDU reaches send_err_rsp(), and the sdp_svc_search_req(), sdp_svc_att_req() and sdp_svc_search_att_req() handlers allocate as well, so a short burst of pipelined requests drains the pool and parks the RX context in the blocking allocation.
A pool buffer is released only once its response has been sent, and a peer that withholds baseband acknowledgements keeps the controller's buffers for the link full, so the response is never sent. While the RX context is blocked, the entire Bluetooth host, for all connections and both LE and BR/EDR, stops processing normal-priority HCI events and received data. In most affected releases the stall is permanent. Queued PDUs are freed only by connection or channel teardown, which waits for the normal-priority Disconnection Complete handler, and that handler runs on the blocked RX context, so the host does not recover without a reset. In v3.7.0 through v4.1.x the TX processor discards the queued response once the link supervision timeout drops the connection, so each stall ends at that timeout, but the peer can reconnect and repeat it for as long as it stays in range. The impact is limited to availability; no memory corruption or information disclosure is involved.
The fix adds sdp_svc_create_pdu() using K_NO_WAIT, pre-allocates the response buffer once in bt_sdp_recv(), stashes the request in sdp->recv_pending when no buffer is available, and retries it from a work handler once a buffer is freed by the pool destroy callback. |
| The Bluetooth Classic SDP client built its outgoing request PDUs with bt_sdp_create_pdu(), which allocates from the sdp_pool net-buf pool with a K_FOREVER timeout and no failure handling, in sdp_client_ss_search(), sdp_client_sa_search() and sdp_client_ssa_search() in subsys/bluetooth/host/classic/sdp.c. All of these run on the Bluetooth workqueue bt_workq (via sdp_client_work_handler(), the L2CAP sdp_client_connected() callback, or the continuation-state follow-up from a received response), which is the same single thread that dispatches incoming HCI ACL and event traffic, drives L2CAP, and performs connection and channel teardown. sdp_pool holds only CONFIG_BT_MAX_CONN buffers (one by default) and is shared with the SDP server role.
An unauthenticated peer within BR/EDR range can drive both halves of the trigger. The SDP L2CAP server is registered at BT_SECURITY_L0, so any inbound SDP request makes the device allocate the pool's buffer for a response, which is held until the controller has transmitted it. The same peer can then cause a client request to be issued while the pool is empty: in-tree profiles start SDP discovery from inbound connection callbacks (for example hfp_hf_accept() calls bt_sdp_discover() through hfp_hf_create(), and hfp_ag.c mirrors this), and a peer acting as an SDP server can force repeated client requests by answering with partial responses carrying continuation state.
With the pool empty, the allocation blocks uninterruptibly and freezes the entire Bluetooth host. The stall becomes permanent when the release of the outstanding buffer itself depends on the blocked workqueue: if the link carrying the queued PDU is dropped or stalls, hci_disconn_complete() and the L2CAP channel cleanup that purges the channel TX queue are themselves bt_workq work items, so the buffer is never returned. The result is an unrecoverable denial of service of all Bluetooth functionality until reboot; there is no memory-safety, confidentiality or integrity impact.
The fix allocates client PDUs with K_NO_WAIT via a new sdp_client_create_pdu(), propagates -ENOBUFS, parks the session on a new SDP_CLIENT_FLAG_WAIT_FOR_TX_BUF flag, and adds an sdp_pool destructor that re-submits the SDP client worker when a buffer becomes available. Note that the SDP server role still allocated from the same pool with K_FOREVER at this commit; that path was addressed separately. |
| LibreOffice Writer can save documents in DOCX format. A document can contain content controls whose values are bound to custom XML data, and that data is updated with the current values when the document is exported, including in a conversion run from the command line. Values taken from the document were not escaped where they were used, so a crafted document could write a file of its choosing anywhere the user can write when it was exported to DOCX. In fixed versions these values are written into the document directly, and the XSLT transformations LibreOffice runs can no longer write files or use the network. |
| In EDB Postgres Extended Server and EDB Postgres Advanced Server versions 15 through 18 with Transparent Data Encryption (TDE) enabled, the key used to encrypt temporary files was incompletely initialized. The code applied sizeof() to a pointer to the key buffer rather than to the buffer itself, so only 8 of the intended 32 bytes were filled from a secure random source and the remaining 24 bytes kept whatever was already in memory. This reduces the guaranteed randomness of the temporary-file key from 256 bits to 64 bits. Exploiting this requires local read access to the server's temporary-file directory, and those files normally exist only while the server is running; they persist only after a crash and are removed at the next server start. Permanent data files and WAL are not affected. The issue is fixed in EDB Postgres Extended Server 15.20, 16.16, 17.12 and 18.7 and EDB Postgres Advanced Server 15.20.0, 16.16.0, 17.12.0 and 18.7.0; the server must be restarted after upgrading. |
| Dell PowerStore contains a use of a weak cryptographic algorithm vulnerability that could allow an attacker with existing privileged access to the appliance to recover stored credentials. |
| LibreOffice can open PDF files in Draw, where the PDF import converts each page into drawing objects that can be edited. Images in the PDF, including images with a transparency mask, are converted along the way. An out-of-bounds write existed when an image with a transparency mask was converted, because positions taken from a crafted image were not checked against the size of the image buffer. In fixed versions the image size is limited, and the position of each mask pixel is checked before it is written. |
| Blind SQL injection vulnerability in the public endpoint `public/webhook/receiver.php` of the WhatsApp module for Dolibarr 1.9. The phone number value derived from the `data.key.remoteJid` parameter, received via a JSON request, is incorporated into an SQL query without escaping or parameterization. With the WHATSAPP_WEBHOOK_ALLOW option enabled, an unauthenticated remote attacker could manipulate this parameter to alter the query. Exploitation using a timing-based technique could allow an attacker to extract information from the database and cause service disruption. |
| NVIDIA Megatron-LM contains a vulnerability in checkpoint loading where an attacker could cause deserialization of untrusted data. A successful exploit of this vulnerability might lead to code execution, information disclosure, and data tampering. |
| : Cleartext Storage of Sensitive Information vulnerability in Johnson Controls Open Blue Companion Android App on Android allows : Retrieve Embedded Secrets from Software.
This issue affects Open Blue Companion Android App: before R2.22.0. |
| Improper input validation in Smart Switch prior to version 3.7.74.1 allows adjacent attackers to install arbitrary applications. User interaction is required for triggering this vulnerability. |
| Insufficient session expiration in Smart Switch prior to version 3.7.74.7 allows adjacent attackers to bypass device authentication. User interaction is required for triggering this vulnerability. |
| Integer overflow in V8 in Google Chrome prior to 157.0.8103.78 allowed a remote attacker to execute arbitrary code inside the sandbox via a crafted HTML page. (Chromium security severity: High) |
| Improper input validation in Bixby prior to version 4.1.20 allows remote attackers to launch arbitrary activity with Bixby privilege. |
| Improper input validation in Samsung Members prior to version 5.8.20.31 allows local attackers to launch arbitrary activity with Samsung Members privilege. |
| Cross-site request forgery in Samsung Health prior to version 7.1.0.053 allows remote attackers to access sensitive information. User interaction is required for triggering this vulnerability. |
| LibreOffice can import EMF, EMF+ and WMF images, which may be embedded in documents. Several out-of-bounds reads existed in the readers for these formats, because sizes, counts and offsets taken from a crafted image were not checked against the data the image actually holds. In fixed versions these values are checked against the size of each record and the data that remains, and a record that fails the checks is not used. |
| LibreOffice has an option, called stealth mode in earlier advisories, that stops documents from outside the trusted file locations from loading linked images and other content. The option is not on by default. With the option on, a linked background image in an HTML document was still fetched while the document was imported. In fixed versions a linked background image is checked against the option like other linked images, and is not fetched when the option blocks it. |
| LibreOffice can export documents to PDF protected by a password. With the PDF 2.0 option the file is encrypted with 256-bit AES, using a file encryption key and salts that are meant to be random. The key and the salts were drawn from a pseudo-random number generator that is not suitable for cryptography, so the encryption key of an exported PDF could be recovered without knowing the password. In fixed versions the key and the salts are drawn from the random source of the operating system. |
| A flaw was found in Red Hat Quay. The v1 registry API error handler reflects the attacker-supplied image_id path segment in a response served as text/html, allowing a reflected cross-site scripting (XSS) attack. By tricking a user into visiting a specially crafted URL, a remote attacker can execute arbitrary JavaScript in the victim's browser within the Quay origin, potentially compromising the user's session. |